EEVblog #186 - Soldering Tutorial Part 3 - Surface Mount

Channel:EEVblog · Length:39:55 · Published:2011-07-15 · Views:1412367

Watch on YouTube

Summary

Dave Jones of EEVblog shows hand soldering of surface-mount parts, including drag soldering and tack-and-reflow of 0.5mm fine-pitch ICs, with solder paste and hot air.

Why HN recommends it

Recommended as a good introduction to SMD soldering techniques for beginners.

Check out Dave Jones' multi-part videos on soldering — HN, 2020

Electronics & circuit design · Repair, teardowns & right to repair

Subtitles (excerpt)

Hi, welcome to the AAVlog an electronics engineering video blog of interest to anyone involved in electronics design. I'm your host, Dave Jones. Hi, it's surface mount soldering time part three in the hand soldering tutorial. And today we're going to do surface mount technology. We've looked at that the tools in the first part through hole components in the second part and surface mount a lot of people think it's a really hard but it's not. It's an absolute piece of cake. Use the basic techniques you did last time, few more little tricks and you can solder really first class stuff with not much experience at all and some very basic tools. Let's take a look at it. Let's start out by looking at some basic surface mount components here. Up here is your standard quarter watt through hole resistor everyone's familiar with. Now this is a 1206 size surface mount resistor. This is a 80805 surface mount ceramic capacitor. This is an the same size 0805 surface mount resistor. This is an 0603 surface mount resistor and this is an 0402 surface mount resistor. They do come even smaller than this tiny ones that are used in really ultra miniature mobile phones and things like that. Now the 1206 but these are the basic standard sizes that you'll deal with in terms

On Hacker News

It's really not difficult to solder SMD components. See e.g. [VIDEO] for a good introduction to the relevant techniques. — foldr, 2020-10
Meta : You can open an account at: [LINK] [LINK] [LINK] These are forums with extremely helpful members. The format is different than Stack Overflow's "Question/Answer". It is built on the "Post/Thread". You can have threads that go on for 40 pages and span a year, when someone is doing a project, and these magnificent creatures will accompany the users with feedback. One thing I've done when sta… — Jugurtha, 2020-08
It's actually pretty simple to hand solder a TQFP by drag soldering. The key is to use plenty of flux and have solder braid handy to take care of any bridges. [VIDEO] It's sort of a moot point with this Cortex A8 IC though, because the RAM it needs only exists in a BGA package. — nrp, 2012-04

Related videos