KiCad 6 STM32 PCB Design Full Tutorial - Phil's Lab #65

Channel:Phil’s Lab · Length:1:40:05 · Published:2022-07-05 · Views:1005468

Watch on YouTube

Summary

A 100-minute tutorial from Phil's Lab on designing an STM32-based 'black pill' PCB in KiCad 6. It covers schematic capture, two-layer layout and routing, USB, and sending the board for manufacture and assembly.

Why HN recommends it

HN recommends it as a practical way to learn KiCad and PCB design by following one full project.

The Youtube channel Phil's Lab has a really good series — HN, 2024

Electronics & circuit design · Embedded systems & DIY electronics

Subtitles (excerpt)

Thank you very much to everyone who has supported me and this channel over the last 2 years. The KiCad and STM32 tutorial video you see here has reached nearly a million views, which is amazing. So, thanks again. As has become somewhat of a ritual on this channel, this new extended video you are watching right now will guide you through KiCad version 6 this time and how to create a simple but complete STM32 based hardware design from project creation through to getting your PCBs manufactured and assembled. Some of you may recognize this as the Udemy KiCad version 6 course, which it is, and I have as of now decided to make it free of charge so that a larger audience can hopefully benefit from the information. The earnings from the Udemy course to date have covered my development costs, so thank you to everyone who gave generously. This course is still available on Udemy under the title Learn KiCad version 6 and STM32 hardware design for anyone that would like to receive a certificate. If you would like to up your hardware design skills and support me and this channel even further, I would encourage you to sign up to my Mix Signal hardware design with KiCad version 6 course, which you can find under this link

On Hacker News

Checking the datasheet is essential, they usually show the “must-have” parts around a chip. Beyond that, good habits are adding decoupling caps close to the pins, keeping ground solid, and following the reference layout. I also learned a lot just by listening to experienced designers explain their choices, like here: [VIDEO] — waerhert, 2025-08
I'm in embedded also, I started this journey at work doing board bring-up. I wrote drivers mostly, not doing any direct electrical work, but after reading the schematics I thought, "oh wow, so that's how they do schematics professionally," followed by "wait, I can do that!" Before that, I just did a few small things with Arduino. The Youtube channel Phil's Lab has a really good series [1] on PCB … — mlsu, 2024-04
A few months ago, you would have been on Kicad 6 (assuming you didn't pull some ancient 5.0 release from your distro), which I've found to have a great UI. Like all EDA software, the UI is optimized for power users, and therefore has some quirks and a learning curve for the hotkeys, but I would not say that Kicad is phenomenally bad. Work your way through one tutorial (eg. this recent one: [VIDEO… — LeifCarrotson, 2022-10
Wow, what a coincidence! Thank you for posting, this looks like a great resource. I am (a very novice, no EE background hobbyist) creating my first design right now. It seems like there are a lot of design rules that are not common knowledge. And in the electronics tinkering "community" there is basically a vertical wall in the learning curve after Arduino/breadboard. I work on embedded software … — mlsu, 2023-12

Related videos