How to achieve nanometer precision in space?

Channel:Breaking Taps · Length:11:06 · Published:2022-02-07 · Views:750202

Watch on YouTube

Summary

Breaking Taps explains how the cryogenic mirror actuators on the James Webb Space Telescope achieve nanometer precision using flexures. It shows a 3D-printed replica and how one motor handles both coarse and fine motion.

Why HN recommends it

Commenters repeatedly recommend it in JWST threads as a great explanation of clever mechanical design that is accurate and long lasting.

I highly recommend — HN, 2022

Space exploration & spaceflight · Mechanical & precision engineering

Subtitles (excerpt)

there is a lot of really cool technology packed into the james webb space telescope everything from the reflector the size of a tennis court but thinner than a human hair the cryo cooler keeping the instrumentation super cold the ultra lightweight brilliant mirrors everything about it is just a technological marvel but i think the most impressive piece of technology on the entire telescope is this this is a working replica of the jwst mirror actuators it's possibly the coolest mechanism that i've seen in quite a while so i decided to build one these actuators are required because jwst's primary mirror is composed of 18 hexagonal segments and these segments eventually will form a concave ellipsoid which will reflect the light into the instruments but this is a really challenging task because each of the segments needs to be aligned in seven degrees of freedom to nanometer precision which is difficult on earth let alone on a satellite out in space the actuator that we're looking at today handles the kind of kinematic adjustments so there's tip tilt roll y translation x translation and then piston or z translation the seventh degree of freedom is actually the curvature of the mirror itself and that's handled by a different actuator as if this wasn't difficult enough

On Hacker News

The actuator is a genius flexure design that is both mechanically simple and accurate. Breaking Taps 3d-prints a working replica and describes the design. I highly recommend: [VIDEO] The actuator breaking wasn't as concerning after seeing the design. — infogulch, 2022-03
I have a related question, how far are you turning the thumbscrews when making adjustments? I think M3 standard thread pitch is 0.5mm, so to a first approximation that almost 1000 wavelengths (if I have the SI units right in my head, and I'm not 3 orders of magnitude out?). I suspect the left/right and up/down adjustments have as fairly high lever ratio, but I can't imagine you could successfully… — bigiain, 2026-01
This video [VIDEO] was posted here [LINK] about how the actuators work on the James Webb telescope. It's a great watch. — mywacaday, 2022-04
Here a nice video that explains the mechanism that aligns each mirror: [VIDEO] It is amazing that this is done with only a single motor. It works something like this: one direction of the motor sets which axis to align, the other direction sets the alignment of the chosen axis. — blenderdt, 2022-03
This video [VIDEO] was posted here [LINK] about how the actuators work on the James Webb telescope. It's a great watch and shows how well thought out design can produce accurate and long lasting parts. — mywacaday, 2022-03

Related videos